Ultra Reduction Ridge Bracelet
$495.00
| Materials | AS |
|---|---|
| Finish | ACID |
| Dimensions | Band width: 7mm |
| Weight | 25g |
This piece is 100% hand fabricated from metal plate; cut into sections and soldered together to make the hollow three dimensional form. If sterling silver, the sheet metal is made by hand. The silver is melted and rolled out into plate.
Acid Silver: brass substrate is electroplated with silver and then dipped into acid to create the subtly destroyed surface. The concentration of the plating solution, air temperature and time in the acid bath all play integral roles in the final result and exist in a delicate balance.
It uses creation methods and finishing techniques that vary from piece to piece. All processes are done by hand and therefore variation in the final product should be expected and will not be exactly as seen in the photo.
Size S is currently available.
Do not hesitate to contact us if you would like to customize in any materials, width or size.
*Please make your size selection with care as we do not refund on made to order pieces.
Size guide
OPEN-TYPE BRACELETS have two key points to consider.
Firstly the actual ‘size’ (Column A) which is measured by using your wrist diameter. You want there to be a little wiggle room so select the size that is just slightly bigger than your actual wrist measurement.
The second key point is the thickness of your wrist, this is important to be sure you can get into the opening (Column B) but that it is not too big that the bracelet will fall off. This measurement can be a bit snug, it is best to have to squeeze into the opening part of this bracelet a bit to prevent it from falling off.
The other factor to consider where on your arm you will wear this. If you are stacking multiple bracelets you would need a size up to wear higher.
